Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Community bulletin board / Re: Thanks and request for help

« on: November 19, 2009, 11:16:33 AM »

Mnemonic was right. 2 bones from foots removed in proces of work causes problem with missing SkinWeights lines in exported .x file. In spite of repainting weights in Blender for all remaining bones after removal. Rebuilding all armature from the beginning helps. Now it loads with animation without crashes in WME  

2

Community bulletin board / Re: Thanks and request for help

« on: November 17, 2009, 10:30:07 AM »

When i try to export simple cylinder with 2 bones and simple animation all works just fine in ProjectMan.

The problem, i think, is with weight paint on my blender mesh - in complex model when try to export x file is no SkinWeight at all. I'll do that part with armature creation, weight paint and animation from scratch again and will see.

3

Community bulletin board / Re: Thanks and request for help

« on: November 15, 2009, 01:37:25 PM »

Thanks Mnemonic for the fast responce.
In bone names i have _ but no spaces...
Maybe there is some space after some name... I'll check all right now.

good engine, good support 

4

Community bulletin board / Thanks and request for help

« on: November 15, 2009, 01:24:23 PM »

First of all, thanks for this great engine!
I have some troubles importing 3d actor into Wintermute Project Manager.
Here is the problem:
The actor was created in Blender 2.49
Before any rigging and animation i'v tried how it will look like into Wintermute. Following wonderful article in knowledge base it was easy and all went right. I export it from blender using standart .x exporter and replase trinity.x with my model. T-pose with textures was there.
But when i made some rigging and idle animation Wintermute Project Manager crashes if i try to view trinity.act3d. Here is what the log file say:
11:04: Warning: Cannot find frame 'Ђ
'
11:04: Warning: Cannot find frame 'pЬреЂ
'
and every time there are diferent frames with 'strange' characters wich can't be found.
Blender export all without errors in console, there is no bones with cyrillic names, no matter if i export with or without animation - there is an error. I suppose that armature is the problem, but what exactly...
If i export just meshes there is no problem.
Thanks in advance for any help!