Please login or register.

Login with username, password and session length
Advanced search  

News:

For WME related articles and tutorials visit WME Resource Center.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Connway

Pages: 1 [2]
16
Technical forum / Help for a beginner
« on: June 16, 2006, 09:26:34 PM »
I'm new to the Wintermute Engine and have started a simple project to help me learn the basic functions. I have read some of the Wintermute Documentation, but not all of it.

I've encountered some problems with my project. As you can see from the below shots, the stick figure stops short of top wall and can go way too far down the bottom wall.




I'm not sure if this has anything to do with the problem, but I have set the hot spot to the bottom-right corner of the sprite images.



But, as you can see below, I cannot place the top of the head of my sprite outside any of the "floor" region.




Basically, I'd like the engine to block the actor from moving if the feet reach a certain point.

Any help would be appreciated.

Thanks

Pages: 1 [2]

Page created in 0.032 seconds with 19 queries.